* Full charge the transmitter and the receiver before using.
How to Use the Transmitter:
1). To turn on/off the Transmitter, Press the mode button on the Transmitter for 5 seconds.
2). By pressing the Mode button to select different modes ----the LCD images will change.
3). Press the up and down buttons on right hand side to set level.
4). Choose the different channels for different receivers.
5). The Transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.
6). In STANDBY MODE, press any button (except LED light button) to wake it up.
Connect the Transmitter with the Collar Receiver:
1). Turn on the Transmitter and choose 1or 2 channels to encode.
2). Lift the Reset part of the Rubber cover in the Collar Receiver.
3). Use a toothpick or paper click to insert into the Reset HOLE inside the Collar Receiver.
4). Press the LAUNCH button on the Transmitter immediately while you are hearing a beep from the collar.
5). The Collar Receiver will beep , it means that the Transmitter has encoded the collar.
6). After completion, put the rubber cover in the right position to keep the internal unit from dust and water.
Package Content: •1pc x remote control unit
•1pc x collar
•1pc x neck strap
•1pc x charger &cord
•1pc x test light
•2pairs x replacement probes
•1pc x Operating Instructions